Can a 55 Ton Ironworker Punch an Oblong Hole
posted in: Ironworker Comments, Tooling and Dies
0
Can a 55 Ton Ironworker punch a standard oblong hole 13/16″ x 1″ is a 5/16″ thick piece of A36 material ? Yes it can.
Can a 55 Ton Ironworker punch a standard oblong hole 13/16″ x 1″ is a 5/16″ thick piece of A36 material ? Yes it can.
55 Ton Ironworker question. This question had to do with punching a 1/2 inch hole in 2 inch angle iron. The angle iron is 1/4 inch thick. Upon going to another shop where there was an ironworker our contact was … Read More
The 25 Ton Edwards Ironworker is at home in a small fab shop or even an home metal shop. It makes some projects just that much easier. Punching though supports is quicker than drilling. With the second, open station, you … Read More